Certification Explained

Certification Explained Wholesale: Buyer's Incoming QC Checklist

Certification Explained Wholesale: Buyer's Incoming QC Checklist

SECTION 01Why the first 60 minutes after delivery decide your claim

Most wholesale buyers open a carton, glance at the GRA cards, and sign the delivery sheet. That signature is the moment your leverage drops. Once the courier marks the shipment delivered and you have no written exception, a stone swap or a missing certificate becomes your word against the factory's. I have sat on both sides of that conversation for 12 years.

This is the incoming checklist my own QC team would use if we were the buyer. It runs minute by minute for the first hour. Print it, tape it to the receiving table, and do not let anyone open the parcel before the clock starts.

SECTION 02Minute 0 to 5: photograph the carton before you cut it

Put the sealed carton on a clean surface and shoot four sides plus the shipping label. If the tape is lifted, crushed, or re-taped, photograph that corner close up. Courier damage and factory short-shipment are two different claims, and the photo decides which one you file.

Check the DDP paperwork against the invoice. For US and EU buyers we ship DDP, 5 to 8 days door to door, so the commercial invoice, packing list, and any certificate envelope should all be in the same carton. If the certificate envelope is missing at this stage, stop and message the factory on WhatsApp +86 133 7744 7107 before you unpack further.

SECTION 03Minute 5 to 15: reconcile the packing list line by line

Count outer boxes against the packing list first, then inner trays. Do not open any stone parcel until the box count matches. A short box count is easy to prove; a short stone count inside an opened parcel is not.

  • Outer carton count versus packing list
  • Inner tray count per SKU
  • Seal integrity on each stone parcel
  • Certificate envelope count versus invoice
  • Any loose stones rattling in the carton

Write the actual counts on the packing list in pen and initial each line. That annotated sheet is your first evidence file.

SECTION 04Minute 15 to 30: certificate cross-check, the part buyers skip

Now open the certificate envelope. For lab-grown diamond orders you should have IGI certificates; for moissanite you should have GRA cards. Match each certificate number to the stone parcel label, not to the invoice only. A common failure is a correct invoice with a mismatched certificate inside the parcel.

CheckWhat good looks likeRed flag
Certificate bodyIGI for lab-grown diamond, GRA for moissaniteGeneric "gem lab" card with no verifiable number
Number matchCertificate number equals parcel label and invoice lineNumber on card differs from parcel label
Stone specsCarat, color, clarity, measurements match the orderMeasurements rounded or missing
QuantityOne certificate per stone or per stated lotOne card covering a mixed lot

Scan or photograph every certificate flat, in one frame, with the parcel label visible. Do this before the stones leave the envelope. If a number does not match, photograph the mismatch and hold that line from production.

SECTION 05Minute 30 to 45: stone check under the loupe

This is the incoming stone check, the first of our three QC stages. Under 10x magnification, look at table, girdle, and pavilion. For moissanite, confirm the double refraction pattern and check for surface scratches from tray friction. For lab-grown diamond, confirm no laser inscription mismatch against the IGI number.

Weigh a sample of at least 10 percent of the line, or every stone if the order is under 30 pieces. Custom orders start at 30 pieces, stock at 1 piece, so small custom runs get full weighing. Note carat deviation per stone; anything outside the stated tolerance goes on the exception sheet.

SECTION 06Minute 45 to 55: silver, settings, and finish

For 925 silver, check the stamp inside the band or bail, then check the color under daylight, not office LED. Rhodium thickness and tarnish resistance are the two failure points buyers miss. Wipe one piece with a soft cloth and look for drag marks or patchy plating.

Set stones with a probe test, not a fingernail. Look for gaps between prong and stone, and check that every prong tip is rounded. A loose stone found at minute 50 is a production fix; the same stone found by your customer is a refund.

SECTION 07Minute 55 to 60: close the loop in writing

Before the hour ends, send one message with photos, the annotated packing list, and a short exception list. State clearly what is accepted, what is held, and what you want replaced. Factories respond fastest to a numbered list with photos, not to a paragraph of complaint.

If the order came from us, that message goes to service@holycome.com and gets a same-day answer. Our production runs 12 to 18 days, and our cost, speed, and yield run about 20 percent better than typical trading companies because we cut, set, and QC in one building instead of passing the order through three middlemen. Payment terms are T/T 30 percent deposit, with PayPal accepted for samples.

Do not sign the delivery sheet until the certificate numbers and the parcel labels agree. That one habit kills most wholesale disputes before they start.

SECTION 08Frequently Asked Questions

What is the minimum order for a certified moissanite or lab-grown diamond line?

Stock items ship from 1 piece, so you can sample a certificate and a stone before committing. Custom cuts and custom settings start at 30 pieces, with production at 12 to 18 days after deposit.

How do I verify a GRA or IGI certificate at incoming QC?

Match the certificate number to the parcel label and the invoice line, then check carat, color, clarity, and measurements against the order. Photograph every certificate with its parcel label in one frame before the stones leave the envelope.

How is wholesale pricing quoted, and what does DDP include?

Prices are quoted per piece or per carat basis, depending on whether you buy a finished line or loose stones. DDP delivery covers duty and door delivery in 5 to 8 days for US and EU addresses, with T/T 30 percent deposit and PayPal for samples.

Send your next order details or ask for a sample pack with certificates included. Our team will confirm stock, custom MOQ, lead time, and a DDP quote the same working day.

S

Sarah Lin

GIA Graduate Gemologist (G.G.) with ten years of experience in gem identification and colored-stone grading, having examined over 10,000 stones.

Looking for Wholesale Jewelry?

Wuzhou HengliLai Jewelry Co., Ltd. - Professional gemstone and jewelry manufacturer in Wuzhou, China. OEM/ODM services, factory-direct pricing, low MOQ.

Contact on WhatsApp service@holycome.com

Written by the Holycome manufacturing & quality team. Every figure and claim in this article comes from our own production floor in Wuzhou, China — in-house casting, stone setting and a three-pass quality inspection we have run since 2008.

Materials are tested for nickel, lead and cadmium release by SGS and CTT International; moissanite centre stones ship with their GRA warranty card and report. We also hold an independent SMETA / Sedex ethical-trade audit and a Hong Kong Customs AML registration.

Reviewed for accuracy by our quality team before publication. Last updated .