A Care & Cleaning price carries four supply steps: alloy, stone, casting and finishing. Knowing which step a supplier controls explains both the price and the risk.
Alloy comes from a mill, usually in sheet, grain or tube. Stones come from cutting centers, and the cutting quality is set there, not at the setting bench. On Care & Cleaning, a cheap stone usually means a cheaper cut, not a cheaper rough.
Ask which mill and which cutting source. The answer tells you what can change without notice.
Build the landing date from ship date plus transit plus clearance. Planning from the ship date alone makes every season a week late.
Casting is either in-house or subcontracted. In-house means control over the alloy mix and the queue; subcontracted means a shared queue and a longer lead time in peak.
On Care & Cleaning, the casting arrangement is the single best predictor of peak-season reliability.
| Step | Who controls | Risk if opaque |
|---|---|---|
| Alloy | Mill | Purity drift |
| Stone | Cutting center | Grade change |
| Casting | Factory or sub | Peak delay |
| Finishing | In-house or shop | Colour variation |
| Plating | Plating shop | Thickness drift |
Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.
Photograph the first article before the batch runs. A shifted seat or a short prong is cheapest to fix at one piece.
Plating can be in-house or a plating shop. A plating shop serves many clients and its bath chemistry drifts; that drift is the source of colour variation between lots.
Ask for a colour sample per lot, and for the bath maintenance record if the volume justifies it.
A quote that names the mill, the stone source, the casting arrangement and the plating shop is a quote you can audit. A quote that names none of them is a price with no chain behind it.
On Care & Cleaning, that transparency is worth more than a few percent on the unit price.
A repeat order is a test of the factory, not of the design. If the second lot drifts, the process was never controlled, only the sample.
Run the five checks below in order. The first two protect the money, the last three protect the launch date.
If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.
Different alloy sources, cutting quality and casting arrangements. The chain explains the price more than the labor rate does.
In peak season, yes. It decides whether your order holds its slot.
Usually plating bath chemistry. A sample per lot catches it early.
At the level of names: mill, cutting source, casting, plating shop. Four answers make a quote auditable.
A stone source change without notice. The lot looks similar and grades differently.
Split both into metal, stone, labour, finishing and overhead, then compare line by line. A single total hides the specification difference.
Send the Care & Cleaning spec. We return the four-step supply chain with the mill, stone source, casting and plating arrangement named. See the full range at Care & Cleaning and HOLYCOME.
None of this is exotic. It is a document, a measurement and a date, repeated until it becomes a process.
Wuzhou HengliLai Jewelry Co., Ltd. - Professional gemstone and jewelry manufacturer in Wuzhou, China. OEM/ODM services, factory-direct pricing, low MOQ.
Contact on WhatsApp service@holycome.comWritten by the Holycome manufacturing & quality team. Every figure and claim in this article comes from our own production floor in Wuzhou, China — in-house casting, stone setting and a three-pass quality inspection we have run since 2008.
Materials are tested for nickel, lead and cadmium release by SGS and CTT International; moissanite centre stones ship with their GRA warranty card and report. We also hold an independent SMETA / Sedex ethical-trade audit and a Hong Kong Customs AML registration.
Reviewed for accuracy by our quality team before publication. Last updated .